The engine photographs are from the shop, with the valve covers shown in the planned red finish.
Where it starts
From four carburetors to eight throttle bodies.
The original V8, and the same V8 as we change it.
The carbureted 308 breathes through four twin-choke carburetors. The E08's engine gives each cylinder its own throttle body in their place, for a sharper response and the sound that goes with it.
The first two development cars are based on the GTBi, the fuel-injected version of the 308.
On the stand
Built on the bench.
The engine comes out of the car and is rebuilt with new internals.
On a stand, the V8 is taken to a custom 3.5 L on the original power plant. The flywheel is lightened and the clutch upgraded to carry the added power. The engine has been run on the dyno and tuned.
The induction
A throttle body for every cylinder.
Eight individual throttle bodies, one for each cylinder.
This is the engine as it sits in the car, under the rear hatch, with its red plug leads.
Back in the car
Installation.
The finished engine goes back into the car, behind the seats.
It is paired with the original transmission.
The exhaust
A bespoke exhaust, made for the E08.
Lightweight and high-performance.
The exhaust is a bespoke design, made specially for the E08 and its engine.
Own a Ferrari 308? The exhaust is made for the 308 too. Ask the workshop what fits your car.
